Help,video,download-Run MoshiSeeX.exe

http://www.moshisoft.com/soft/MoshiSeeX.exe

Moshisoft QQ group: 612907505
Email: moshi@moshisoft.com

最新更新(Newer)(2017.06.09)
  1、优化模板颜色填充，点击填充色，只有无子对象的才会填充；
        Fill objects when fill mode is clear and the object have not children.
  2、优化设备检测；
        Program check machine again.
  3、支持单轴(刻字机)、双轴无限位开关运行模式；
        Support 1/2 axis have not limited mode. 
        可以定位；每次雕刻、切割完成后，移动到最大坐标，并把坐标清零。
        Can set position.  Set x/y to 0 after cavre and cut. 
  4、添加二维码生成工具QRCode；
        Add QR code tool, get image for code.
(2017.05.19)
  1、添加延时出光、出光延时和延时关光、关光延时；
     Add the delay before open laser and after open laser, delay before close laser and after close laser, 
     延时出光：运行到指定位置，延时后再打开激光
     Delayed before open laser: run to position - delay - open laser
     出光延时：运行到指定位置，打开激光，延时后再运行下一步
     Delayed after open laser: run to position - open laser - delay
     延时关光：运行到指定位置，延时后再关闭激光
     Delayed before close laser: run to position - delay - close laser
     关光延时：运行到指定位置，关闭激光，延时后再运行下一步
     Delayed after close laser: run to position - close laser - delay
  2、添加脉冲激光演示(CA版本主板支持)，间隔1mm，出光比10%
     执行轮廓输出时，可以划出以点组成的曲线，点之间的间隔是1mm
     Add pulse laser demonstration (CA version of the motherboard support), interval 1mm, light = 10%
    Can draw a curve of dots when cut output(the interval between dots is 1mm)
(2017.04.05)
  1、添加脉冲激光输出功能(需配合CA以上版本主板使用)
     Pluse laser output(need version CA controlboard)
     作用：雕刻时，底面更平，深度更均匀；
     Function:The bottom surface is more flat and more uniform depth when carve .
     切割时，缝隙更小，切透率更高，边缘热影响更小。
     The gap is smaller, the penetration rate is higher, and the edge heat effect is smaller when cut.